Search:     Advanced search
Browse by category:
Contact Us
PhotoModeler Knowledgebase / Support / PhotoModeler 4 Issues


Showing: 1-8 of 8  
Articles
 
document I am getting many "Invalid Pen" and "Invalid Brush" messages and then sometimes the program crashes.
*This applies to PhotoModeler Pro 4.0 only. These...
Views: 1102
document I cannot select items in the 3D Viewer.
*This applies to PhotoModeler Pro 4.0 only....
Views: 1237
document I have a hardware lock version of PhotoModeler (parallel port dongled) and I get error messages about the lock not being detected.
There are a number of reasons this might happen. ...
Views: 1241
document PhotoModeler Pro can open the 3D Viewer but it dies when showing photo-textures.
*This applies to PhotoModeler Pro 4.0 only. This...
Views: 1148
document I get the message "Corrupt installation detected" when I run the PhotoModeler installer.
There are two possible reasons for this error...
Views: 1309
document PhotoModeler Pro assert fails or shows a DirectDraw error message every time I bring up the 3D Viewer.
*This applies to PhotoModeler Pro 4.0 only. ...
Views: 2084
document PhotoModeler Version 4 does not run on windows Vista.
PhotoModeler version 4 was developed long before...
Views: 1190
document Modeling Interiors
Interiors can be tricky, but it is possible with...
Views: 3188


Powered by KnowledgebasePublisher (Knowledgebase software)